| Installation Tutorials
Corner Bumper Guards Installation
A step-by-step guide on how to install any of our Corner Bumper Protection products. Our bumper protectors, corner bumper guards, door edge guards, and car door guards. are simple to install. Follow the easy step by step directions for a seamless installation of our bumper protector and rear bumper protectors.
Weather Conditions (Installation):
 |
Hot Weather Installation and Removal Tips
Best installation is at temperatures above > 60 degree F. The hotter the better, as the bumper guards are more flexible and adhere better when warm. Also, removing the bumper protectors is easier when the temperature is hot outside. To remove pull back slowly - if product does not pull off easily use a hair dryer to warm the product or park in direct sun to warm the product. |
|
 |
Cold Climate Installation and Removal Tips
During the cold months when the outside temperature is below <60 degree F, it is best to install the bumper guards indoors (in a heated space). keep the bumper guards indoors until ready to use. For installation below 60 degrees you may need to use a hairdryer or heater to warm the product and/or vehicle surface. Note: The bumper guards get stiffer as the weather gets colder, so removal may be more difficult. A hairdryer can be used to warm the product, which makes removal easier. Heat one section at a time. |
Installation - The following video will demonstrate the correct tips, tools and technique for correct rear bumper guard and bumper protector installation. The installation of bumper guards, door edge guards, and car door protectors is fast and easy. This tips and techniques video will cover the following information: surface preparation, measuring and attachment instructions. Please visit http://www.bumperdefender.com for more information.
Installation - 1" corner bumper guard and front bumper guard basic installation video covers proper surface preparation, measuring, masking and attachment instructions. Our installation video makes installing corner bumper guards and front bumper guards fast and easy.
 |
 |
Tools Required:
Bumper Guard Cutter(straight Edge)
(*Scissors or Pliers will not cut properly*)
Masking Tape
Pencil or Crayon
Measuring Tape
|
If you are not sure of the color, please order a color sample for a best match. Bumper guards are close approximations and may vary slightly from actual color of vehicle.
(*not recommended for repainted bumpers)
|
 |
 |
Measure the bumper from wheel edge to wheel edge to determine bumper protector quantity. We always recommend ordering a few inches extra. |
It is important to clean the application area throughly before installing the bumper guards. The cleaning process will remove any dirt, oils or wax. |
 |
 |
STEP ONE - For a straight installation use masking tape as a guide. Tack one end of the masking tape to the bumper edge and work your way around the bumper. For a straight edge lift the tape as one piece and tack the tape at the opposite end of the bumper. (Note: Tacking down the tape as you move along will result in a crooked line). To reposition lift the entire tape as one piece and reposition. Make sure the tape is perfectly straight by viewing from different angles. This is the hardest part of the installation, so take your time and be patient. |
|
Summary: Corner car bumper guards are the easiest way to protect your front and rear bumper from abrasions. For added car bumper protection you can double up the corner bumper guards one on top of the other. |
|
